Hondata, Inc.

s100

Hondata System

Installation Guide

Introduction

The Hondata s100 is a module that fits internally to a Honda ECU, using the same connector and ROM as the Hondata s200 system.

Installation

The s100 module plugs into the 4-pin connector CN2. If the ECU does not have this connector then see the Hondata installation manual for instructions on how to prepare an ECU for Hondata.

US ECU

JDM ECU

Install the s100 so that the 4 pin ECU connector (CN2) is all the way to the end of the s100 connector.

US ECU

JDM ECU

In the JDM ECU the body of the s100 will sit above some components in the ECU.

It is possible, but not necessary, to hold the s100 in place with some hot glue.

Removing J12

It is recommended to remove jumper J12 from the ECU. This improves communication reliability between the s100 module and the ECU. It is not necessary to cut J12 for JDM ECUs.

Location of J12 for US ECUs

Note that J12 must be replaced if the ECU is used with a Hondata Stage 2/3/4 system.

Specifications

Physical:

· Storage temperature range: -20 - 85 ºC

· Operational temperature range: 0 - 70 ºC

· Maximum shock: 500g

Electrical:

· Voltage: 5 V

· Current consumption: 10 mA

Information furnished by Hondata is believed to be accurate and reliable. However, no responsibility is assumed by Hondata for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or

otherwise under any patent or patent rights of Hondata.

Hondata, Inc.

2341 West 205^th St

Ste 106

Torrance, CA 90501

Tel: 310-782-8278

World Wide Web Site: http://www.hondata.com

© Hondata, Inc., 2002